Automotive Science and Engineering
Iran University of Science & Technology
Tue, Dec 3, 2024
[Archive]
Volume 1, Issue 3 (5-2011)
ASE 2011, 1(3): 165-172 |
Back to browse issues page
Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:
Abbasi M, Kazemi R, Ghafari Nazari A. Using a Parametric Method for Investigating Automotive Crashworthiness. ASE 2011; 1 (3) :165-172
URL: http://www.iust.ac.ir/ijae/article-1-24-en.html
URL: http://www.iust.ac.ir/ijae/article-1-24-en.html
Abstract: (29918 Views)
Parametric design optimization of an automotive body crashworthiness improvement is presented. The thicknesses of parts are employed as design variables for optimization whose objective is to increase the maximum deceleration value of the vehicle center of gravity during an impact. Using the Taguchi method, this study analyzes the optimum conditions for design objectives and the impact factors and their optimal levels are obtained by a range analysis of the experiment results. A full frontal impact is implemented for the crashworthiness simulation in the nonlinear dynamic code, LS-DYNA. The controllable factors used in this study consist of the six inside foreheads structural parts, while design parameters are relevant thicknesses. The most interestingly the maximum deceleration of the vehicle center of gravity is reduced by 20% during a full frontal impact while several parts experience mass reduction.
Type of Study: Research |
Subject:
Body structure and systems
Send email to the article author
| Rights and permissions | |
 | This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License. |
