Volume 4, Issue 1 (3-2014)                   ASE 2014, 4(1): 654-663 | Back to browse issues page

XML Print

Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:
Honarvar Gheysari, Babakhani, Haerian. Study and Simulation of Shot peening Effect on Fatigue Life of a Powder Forged Connecting rod. ASE 2014; 4 (1) :654-663
URL: http://www.iust.ac.ir/ijae/article-1-253-en.html
Study and Simulation of Shot peening Effect on Fatigue Life of a Powder Forged Connecting rod
Honarvar Gheysari , Babakhani , Haerian
Abstract:   (16202 Views)
Shot peening applies a residual compressive stress field (RCSF) on the surface of parts. It also shifts “crack nucleation sites” to sub-surface locations. A nondestructive method of measuring the stresses, Sin2ψ was utilized here and the stress values introduced to Ansys software. For this purpose, uniform stress in all directions was applied on the con rod. Loading on the rod in Ansys had three steps: RCSF caused by shot peening (measured by XRD), and tensile and compressive stresses caused by inertial and gas forces, respectively (calculated). Fatigue Macro of Ansys was resumed carrying out the cyclic loading and thereby, improvement of powder forged connecting rods' fatigue life, caused by shot peening was obtained.
Keywords: Fatigue Life, Shot peening, X-ray Diffraction, Ansys.
Full-Text [PDF 841 kb]   (6349 Downloads)    
Type of Study: Research | Subject: Internal Combustion Engines (ICE, ...)
Add your comments about this article : Your username or Email:
CAPTCHA
Rights and permissions
Creative Commons License This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.

© 2022 All Rights Reserved | Automotive Science and Engineering

Designed & Developed by : Yektaweb