S. Sanaye, M. Dehghandokht,
Volume 1, Issue 3 (5-2011)
Abstract
Thermal modeling of an automotive cabin was performed in this paper to predict the inside cabin air temperature. To implement this task, thermal and ventilation loads were estimated and the mass and energy balance conservation equations for dry air and water vapor with considering a new parameter (air circulation ratio) as well as the balance equations of internal components of a cabin were derived and solved simultaneously. The performance of the proposed thermal modeling of a cabin was compared with the data collected from hot room experimental tests. These tests were run for various design parameters such as evaporating cooling load and cabin size (air volume inside cabin). The comparison of experimental and numerical results showed a good agreement.
Parametric analysis with three parameters namely, vehicle speed, number of passengers, and A/C air mass flow rate was performed to investigate the effects of these parameters on cabin air temperature.
Mr Mohammad Fakhari, Mr Ghanbar Ali Sheikhzadeh,
Volume 10, Issue 1 (3-2020)
Abstract
In this experimental study, heat transfer and pressure drop, ΔP, of a coolant nanofluid, obtained by adding alumina nanoparticles to Ethylene Glycol-water mixture (60:40 by mass), in a automotive radiator have been investigated. For this purpose, an experimental setup has been designed and constructed. The experiments have been performed for base fluid and nanofluid with different volume fractions of 0.003, 0.006, 0.009 and 0.012 and under laminar regime with various coolant flow rates of 9, 11 and 13 lit/min and two air velocities of 3.75 and 2.85 m/s. The thermophysical properties have been calculated using the recently presented temperature dependent models. According to the results, the heat transfer and ΔP increase with increasing the coolant flow and nanoparticles volume fraction. Increasing the air velocity causes enhancement of heat transfer. Although Nusselt number decreases when nanofluid is utilized, it enhances as the nanoparticles volume fraction increases. The performance evaluation using nanofluid in the car radiator shows remarkable enhancement in radiator thermal efficiency. However, the ratio of heat transfer rate to the needed pumping power (Merit parameter) decreases.
