Showing 3 results for Thermal Balance
M.h. Shojaeefard, P. Azarikhah, A. Qasemian,
Volume 7, Issue 2 (6-2017)
Abstract
Heat transfer in internal combustion engines is one of the most significant topics. Heat transfer may take place through thermal conduction and thermal convection in spark ignition engines. In this study, valve cover heat transfer and thermal balance of an air-cooled engine are investigated experimentally. The thermal balance analysis is a useful method to determine energy distribution and efficiency of internal combustion engines. In order to carry out experiments, a single cylinder, air-cooled, four-stroke gasoline engine is applied. The engine is installed on proper chassis and equipped with measuring instruments. Temperature of different points of valve cover and exhaust gases is measured with the assistance of K-type thermocouples. These experiments are conducted in various engine speeds. Regarding to the first law of thermodynamics, thermal balance is investigated and it is specified that about one-third of total fuel energy will be converted to effective power. It is also evaluated that for increasing brake power, fuel consumption will increase and it is impossible to prevent upward trends of wasted energies. In addition, it is resulted that, there is a reduction heat transfer to brake power ratio by increasing engine speed. Furthermore, it is found that, at higher engine speed, lower percentage of energy in form of heat transfer will be lost.
Dr. Ali Qasemian, Mr Pouria Azarikhah, Mr Sina Jenabi Haqparast,
Volume 8, Issue 2 (6-2018)
Abstract
The thermal balance analysis is a useful method to determine energy distribution and efficiency of internal combustion (IC) engines. In engines cooling concepts, estimation of heat transfer to brake power ratio, as one of the most significant performance characteristics, is highly demanded. In this paper, investigation of energy balance and derivation of specific heat rejection is carried out experimentally and numerically. Experiments are carried out on an air-cooled, single cylinder, four-stroke gasoline IC engine. The engine is simulated numerically and after validation with experimental data, the code is run to find out total and instantaneous thermal balance of engine. Results indicate that about one-third of fuel energy is converted to brake power and major part of energy is dissipated through exhaust and heat transfer. Experimental and numerical results show that by increasing engine speed, heat transfer to brake power ratio decreases. It is also observed that increasing engine speed leads to increase of exhaust power to brake power ratio. Finally two correlations for estimation of heat transfer and exhaust power to brake power ratios are obtained.
Mohammad Reza Azmoodeh, Prof. Ali Keshavarz, Alireza Batooei, Hojjat Saberinejad, Mohammad Payandeh Doost, Hossein Keshtkar,
Volume 10, Issue 3 (9-2020)
Abstract
A multi-objective optimization and thermal analysis is performed by both experimental and numerical approaches on a Stirling engine cooler and heater. The power generated is measured experimentally by an electrical engine coupled with the crank case, and the friction is estimated by the difference between the necessary power used for rotating the engine at a specific pressure and speed, versus the actual power measured experimentally. In the experimental approach, different conditions were considered; for example, the charge pressure varied from 5-9 bars, and the engine speed varied from 286-1146 rpm. The maximum power generated was 461.3 W and was reported at 9 bars of charge pressure and 1146 rpm engine speed. Numerical approach was carried to simulate thermal balance for investigations on the effect of friction, engine speed and efficiency on generated engine power. Average values of Nusselt number and coefficient of friction were suggested from simulation results.
The multi-objective optimization was held using DOE method for maximizing engine efficiency and power, and also minimizing pressure drop. The top and bottom boundary values for our optimization were 5-9 bars of pressure and 286-1146 rpm of engine speed; for both helium and carbon dioxide. To do so, all three significance factors (engine speed, efficiency and friction) were given different weights, thus different combinations of weight value was investigated
Amongst different interesting findings, results showed that if the efficiency weight factor changed from 1 to 3, for helium in a specific condition, the optimum engine speed would increase by approximately 30.6 %
