Pouyan Namdar, Hamed Saeidi Googarchin, Seyed Hooman Ghasemi,
Volume 12, Issue 1 (3-2022)
Abstract
In this paper, mechanical properties of welded single lap joints of pure aluminum sheets produced by severe plastic deformation (SPD) are considered. SPD in form of a large pre-strain was imposed to aluminum sheets through the constrained groove pressing (CGP) process. Furthermore, CGPed specimens are joined using the resistance spot welding (RSW) method. Welding time and force are maintained evenly. Welding current is raised until ideal failure mode is observed. Finally, mechanical properties of fusion zone, heat affected zone (HAZ) and base metal of welded SPDed specimens are derived. The results show that by increasing the pre-strain in specimens, an improvement in yield strength, ultimate tensile strength, load carrying capacity, maximum displacement before failure and nugget diameter is observed. Furthermore, sensitivity of these parameters to CGP pass number is considered. Finally, it has been shown that fusion zone and HAZ hardness values can increase by increasing the CGP pass number.
