Showing 2 results for Low Cycle Fatigue
Hojjat Ashouri,
Volume 11, Issue 2 (6-2021)
Abstract
This paper presents low cycle fatigue (LCF) life prediction of an engine exhaust manifold. First Solidworks software was used to model the exhaust manifolds. Then Ansys Workbench software was used to determine stress and fatigue life based on Morrow and Smith-Watson-Topper (SWT) approaches. Thermal fatigue (TMF) of the engine components easily happens due to excessive temperature gradient and thermal stress. Modern exhaust systems must withstand severe cyclic mechanical and thermal loads throughout the whole life cycle. The numerical results showed that the temperature and thermal stresses have the most critical values at the confluence region of the exhaust manifolds. This area was under low cycle fatigue. After several cycles the fatigue cracks will appear in this region. The results of the finite element analysis (FEA) correspond with the experimental tests, carried out in references, and illustrate the exhaust manifolds cracked in this region. Finite element (FE) simulation proved a close correlation between Morrow and SWT criterions results. The lifetime of this part can be determined through finite element analysis instead of experimental tests.
Hojjat Ashouri,
Volume 12, Issue 4 (12-2022)
Abstract
Due to the complex geometry and thermos-mechanical loading, cylinder heads are the most challenging parts among all parts engines. They must endure cyclic thermal and mechanical loading throughout their lifetime. Cast aluminum alloys are normally quenched after solution treatment process to improve aging responses. Rapid quenching can lead to high residual stress. Residual stress is one of the main reasons for failure of cylinder heads. The effect of residual stress on the thermal stress and low cycle fatigue life (LCF) of cylinder heads was studied. For this goal, Solidworks software was used to model the cylinder heads. Then the thermo-mechanical analysis was performed to determine the temperature and stress field in ANSYS software. Finally, the fatigue life analysis that considers residual stress effect was done. The results of finite element analysis (FEA) proved that the effect of residual stress in LCF is significant which is not negligible. Thus, residual stress must be considered in the thermo-mechanical fatigue analysis of the engines cylinder heads. The numerical results showed that the area where the maximum temperature and stress is occurred is where the least LCF is predicted.
