Volume 11, Issue 3 And A (Transaction A: Civil Engineering, September 2013)
IJCE 2013, 11(3 And A): 199-205 |
Back to browse issues page
Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:
Salamatian M, Zarrati A R, Zokaei S A, Karimaee M. Study on scouring around bridge piers protected by collar using low density sediment. IJCE 2013; 11 (3) :199-205
URL: http://ijce.iust.ac.ir/article-1-618-en.html
URL: http://ijce.iust.ac.ir/article-1-618-en.html
Abstract: (16987 Views)
The efficiency of a collar in reducing the scour depth around circular and rectangular piers is studied at different flow intensities (ratio of upstream shear stress to sediment critical shear stress). Rectangular Piers aligned with the flow as well as skewed at 5º, 10º, 20º were examined. Previous studies had shown that with collar the equilibrium time of scouring increases considerably. To reduce the time of experiments low density sediment was used as the bed materials. Comparison between test results and available results with natural sediment showed that, though the relative equilibrium depths were approximately similar, the time to reach equilibrium condition diminished to less than 10 hours with low density sediment. Experimental results for circular and aligned rectangular pier showed that at u*/u*c=0.95 to 0.75 the collar could reduce the maximum scour hole from about 20% to 60% respectively. In rectangular pier, by increasing the skew angle and/or the flow intensity, the efficiency of collar decreased.
Type of Study: Research Paper |
Subject:
Water-River
| Rights and permissions | |
 |
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License. |
