Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:

---

Because of the complexity of the physical processes in the vicinity of the hydraulic structures due to the separation of the flow, traditional methods for for prediction of maximum scour depth downstream of hydraulic structures are mostly based on empirical approaches. Hence, only a few theoretical works have been reported to study this phenomenon. The present paper describes a new approach based on the momentum principles to estimate the maximum local scour depth downstream of a submerged sluice gate flowing over horizontal or adverse stilling basin. A control volume of the fluid in the equilibrium state of the scour hole was considered and based on momentum principles, some equations are derived to estimate the scour depth at equilibrium state. To verify the proposed equations, large numbers of experiments were planned and conducted under wide range of characteristic parameters such as, incoming Froude number, sediment size, tailwater depth, length and slope of the apron. It was found that the proposed equations fall in a good agreement with experimental results. It was also observed that, in the case of horizontal apron, a specific tailwater depth exists with which the local scour depth attains a minimum value. However, in the case of adverse basins when the tailwater depth takes a specific value, the maximum depth of the scour hole reaches to its maximum and then decreases to a constant value as the tailwater depth increases. This critical tailwater depth was formulated using a semi-theoretical equation.

Keywords: Local scour, Momentum principle, Sluice gate, Submerged jet, Adverse Stilling basin

Full-Text [PDF 2205 kb]   (4590 Downloads)    

Add your comments about this article : Your username or Email:

---