This paper has applied operation research to solid waste disposal by which two objective functions are optimized to minimize the expected operational costs (maximize revenues) and the expected net carbon dioxide equivalent (CDE) emissions. Types and uncertain amounts of solid wastes as well as costs of electricity were factored into the selection decision of solid waste disposal, i.e. landfill, incineration, composting and recycling. An optimization model was applied to the solid waste disposal of Bangkok, Thailand. In addition, a multi-objective optimization technique was proposed for a tradeoff decision-making between minimum operational costs and CDE emissions. Composting and landfill are effective alternatives for Bangkok’s solid waste disposal system. The operational costs and net CDE emissions are highly correlated with the quantity of solid waste. Policy-makers and plant operators could adopt the proposed optimization model under uncertainty in the selection of an optimal solid waste disposal.

This paper outlines the effects of curing conditions on the strength and hydration products of lime activated slag cement. The slag cement was prepared by activating the ground granulated blast furnace slag with lime and plaster of Paris. The curing of mortar specimens was done at temperatures of 27⁰, 45⁰,60⁰,75⁰C and the compressive strength of specimens were determined after curing periods of 3,7, 28, 56 and 90days. The curing temperature is found to influence both the early and later age strengths. For the present test conditions the highest 90days compressive strength was found to be 47.63MPa for the specimen cured at temperature of 60⁰C. Further, the developed strength in mortar specimens were correlated with the hydration products and microstructure using X-ray diffraction and scanning electron microscope results. Generalized reduced gradient technique is adopted to find the optimum curing temperature for the given raw material composition and this is found to vary marginally on curing period. 

The reinforced concrete bifurcation in hydropower station is consistently under high internal water pressure, and its diameter is usually larger than common duct junctions. In order to diminish or to decrease the heavy plastic zone and stress concentration, structure rounding is commonly used on bifurcation. This will bring some changes to the flow characteristic of bifurcation, and it is an interesting attempt to figure out the influence of structure rounding optimization. The Realizable k-ε model was employed in Computational Fluid Dynamics numerical simulation. The water pressure distribution was compared quantitatively at several certain sections. Furthermore, uneven pressure is analyzed by relative standard deviation. Hydraulic characteristics are discussed as well, including flow pattern, excavation volume and head loss in different working conditions. The results indicate that the pressure of pipe wall is uneven, and the maximum and minimum pressure value has a differential of 0.3% - 1.2% compared to relative static water pressure. The pressure unevenness will increase after structure rounding, and it has a positive correlation with structure rounding radius. At the same time, it is more reasonable for structure rounding in obtuse angle region than that in acute angle region, on account of well-distributed flow conditions and better economic benefit.