International Journal of Industrial Engineering & Production Research

Abstract

The reliability and safety of any system is the most important qualitative characteristic of a system. This qualitative characteristic is of particular importance in systems whose functions are under various stresses, such as high temperature, high speed, high pressure, etc. A considerable point, which is rarely taken into account when calculating the reliability and safety of systems, is the presence of dependency among subsystems, and this dependency causes various failures in a system, one of the most important of which is the common cause failure (CCF). Failing to consider common cause failures in the calculation of system reliabilities, leads to optimistic estimations of system reliability rates, which results in too much trust in the system. In this paper, first we deal with identifying the reliability of the input of a dynamic positioning system consisting of different environmental sensors and various positioning systems with the aid of PBS and FFBD techniques. Then, we will calculate and allocate the above-mentioned reliability with the aid of a RBD. The common cause failures of different subsystems were considered in calculating the reliability of the previously mentioned system, with the aid of IEC 61508 standard, and then the degree of the effectiveness of common cause failures on the reliability of the studied system, was obtained. Finally, by considering different assumptions for the system under study, it was proved that the less the amount of the reliability of dependent components is, the higher the effectiveness of common cause failures on the system reliability will be