Search published articles


Showing 2 results for Rohani

Mr. Mohammad Rohaninejad, Dr. Amirhossein Amiri, Dr. Mahdi Bashiri,
Volume 26, Issue 3 (IJIEPR 2015)
Abstract

This paper addresses a reliable facility location problem with considering facility capacity constraints. In reliable facility location problem some facilities may become unavailable from time to time. If a facility fails, its clients should refer to other facilities by paying the cost of retransfer to these facilities. Hence, the fail of facilities leads to disruptions in facility location decisions and this problem is an attempt to reducing the impact of these disruptions. In order to formulate the problem, a new mixed-integer nonlinear programming (MINLP) model with the objective of minimizing total investment and operational costs is presented. Due to complexity of MINLP model, two different heuristic procedures based on mathematical model are developed. Finally, the performance of the proposed heuristic methods is evaluated through executive numerical example. The numerical results show that the proposed heuristic methods are efficient and provide suitable solutions.

\"AWT


Ali Vaysi, Abbas Rohani, Mohammad Tabasizadeh, Rasool Khodabakhshian, Farhad Kolahan,
Volume 29, Issue 3 (IJIEPR 2018)
Abstract

Nowadays, the CNC machining industry uses FMEA approach to improve performance, reduce component failure, and downtime of the machines. FMEA method is one of the most useful approach for the maintenance scheduling and consequently improvement of the reliability. This paper presents an approach to prioritize and assessment the failures of electrical and control components of CNC lathe machine. In this method, the electrical and control components were analyzed independently for every failure mode according to RPN. The results showed that the conventional method by means of a weighted average, generates different RPN values ​​for the subsystems subjected to the study. The best result for Fuzzy FMEA obtained for the 10-scale and centroid defuzzification method. The Fuzzy FMEA sensitivity analysis showed that the subsystem risk level is dependent on O, S, and D indices, respectively. The result of the risk clustering showed that the failure modes can be clustered into three risk groups and a similar maintenance policy can be adopted for all failure modes placed in a cluster. Also, The prioritization of risks could also help the maintenance team to choose corrective actions consciously. In conclusion, the Fuzzy FMEA method was found to be suitably adopted in the CNC machining industry. Finally, this method helped to increase the level of confidence on CNC lathe machine.

Page 1 from 1