Abstract: (13122 Views)
In this paper the chemical interaction between catalyst and support has been studied to understand the observed different growth rate of CNTs in our previous paper. Both pure MgO and Mg(NO3)2 . 6H2O as sources of the MgO catalyst support and Fe2(SO4)3 · xH2O as the source of the Fe catalyst, were employed. A Fe catalyst supported on MgO has been synthesized using the wet impregnation method followed by calcination. To compare the catalyst grain size and its distribution, the sample were characterized by scanning electron microscopy (SEM), transmission electron microscopy (TEM), X-ray powder diffraction (XRD) and BET specific surface area (SSA) measurement and X-ray photoelectron spectroscopy (XPS). XPS technique have utilized complementary to demonstrate the existence of chemical interaction between MgO support and Fe catalyst. Results revealed that the type of precursor used to prepare the support has a significant influence on the morphology of the support and the associated distribution of the Fe catalysts. The highest yield of MgFe2O4 phase was obtained using a pure MgO precursor which after calcination results in a homogenous distribution of nano-sized Fe particles over the support surface
Full-Text [PDF 1384 kb]
(3494 Downloads)
- Two different precursors (MgO and Mg(NO3)2 . 6H2O) used to prepare MgO support.
- Although single phase of MgO as support material was achieved from two different precursors, they caused different catalyst/support morphology and grain size.
- By employing MgO precursors more MgFe2O4 phase was obtained which improved homogeneous distribution of catalyst particles.
Type of Study:
Research Paper |
Subject:
Ceramics