Iranian Journal of Materials Science and Engineering
Iran University of Science & Technology
Sat, Nov 23, 2024
[Archive]
Volume 19, Issue 1 (March 2022)
IJMSE 2022, 19(1): 1-14 |
Back to browse issues page
Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:
Rezaei Ashtiani H R, Moghaddam S. Experimental and Numerical Investigation on the Heat Treatment Effects of AA6063 Aluminum Alloy Tubes During Rotary Draw Bending. IJMSE 2022; 19 (1) :1-14
URL: http://ijmse.iust.ac.ir/article-1-2066-en.html
URL: http://ijmse.iust.ac.ir/article-1-2066-en.html
Abstract: (8803 Views)
In this study, the effects of heat treatment of aluminum alloy on the tube bending process were investigated in the rotary draw bending process. As two experimental and numerical simulation methods were used to determine the wall-thinning, ovality, and spring back for extruded, annealed, and aged AA6063 aluminum alloy tubes in different bending angles and bend radii. Numerical simulations were done by the finite element method with Abaqus software. The results indicated that in comparison with annealed and extruded parts, wall-thinning reduced whereas the amount of ovality and spring-back increased in the aged tubes. Also, in each case, the percentage of wall-thinning decreased with increasing bend radius, and the effect of bend radius was greater in the reduction of ovality from the bending angle. Investigations showed that the spring-back rate also decreased with an increasing bending angle.
Type of Study: Research Paper |
Subject:
Ceramics
Send email to the article author
| Rights and permissions | |
 |
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License. |
