Numerical Optimization of Successive Ionic Layer Adsorption and Reaction Synthesized Zinc Oxide Thin Film as Electron Transport Layer for Organic and Perovskite Solar Cells

V, Rakhesh; P, Sreedev; A, Ananthakrishnan

doi:10.22068/ijmse.3463

Volume 21, Issue 2 (June 2024) IJMSE 2024, 21(2): 1-17 | Back to browse issues page

‎ 10.22068/ijmse.3463

Mendeley

Zotero

RefWorks

V R, P S, A A. Numerical Optimization of Successive Ionic Layer Adsorption and Reaction Synthesized Zinc Oxide Thin Film as Electron Transport Layer for Organic and Perovskite Solar Cells. IJMSE 2024; 21 (2) :1-17
URL: http://ijmse.iust.ac.ir/article-1-3463-en.html

Numerical Optimization of Successive Ionic Layer Adsorption and Reaction Synthesized Zinc Oxide Thin Film as Electron Transport Layer for Organic and Perovskite Solar Cells

Rakhesh V

, Sreedev P

, Ananthakrishnan A

Abstract: (5360 Views)

Organic and Perovskite solar cells have attracted a lot of attention recently since they can be used with flexible substrates and have lower manufacturing costs. The configuration and materials employed in their construction, including the Electron Transport Layer (ETL), active layer, electrode contact, and hole transport layer greatly influence the stability and performance of these solar cells. This research focuses on the simulation of solar cells, specifically utilizing zinc oxide (ZnO) as the electron transport layer. A 0.1 molar ZnO thin film was prepared from Zinc acetate salt and was deposited on a glass substrate using the cost effective Successive Ionic Layer Adsorption and Reaction (SILAR) method. In-depth investigations were carried out on several factors, including structural, surface, optical and numerical analysis. The obtained parameters were utilized in the General-Purpose Photovoltaic Device Model (GPVDM) software to perform numerical simulations of the organic solar cell and Perovskite solar cell. Both Organic solar cells and Perovskite solar cells were designed numerically and through careful observations, electrical parameters like Open circuit Voltage (Voc), Short circuit current (Jsc), Fill Factor (FF), and Power Conversion Efficiency (PCE) were identified. The studies indicate the promising performance of simulated solar cells with SILAR-synthesized ZnO thin film as the ETL.

Keywords: Thin films, solar cell, Perovskite, Zinc Oxide, SILAR