Superior Photocatalytic Efficiency with Titania (TiO2)-Polyaniline (PANI) Nanocomposite for Rapid Carbol Fuchsin (CF) Dye Degradation

Ahire, Satish; Bachhav, Ashwini; Jagdale, Bapu; Pawar, Thansing; Koli, Prashant; Sanap, Dnyaneshwar; Patil, Arun

doi:10.22068/ijmse.3511

Volume 21, Issue 2 (June 2024) IJMSE 2024, 21(2): 1-19 | Back to browse issues page

‎ 10.22068/ijmse.3511

Mendeley

Zotero

RefWorks

Ahire S, Bachhav A, Jagdale B, Pawar T, Koli P, Sanap D et al . Superior Photocatalytic Efficiency with Titania (TiO2)-Polyaniline (PANI) Nanocomposite for Rapid Carbol Fuchsin (CF) Dye Degradation. IJMSE 2024; 21 (2) :1-19
URL: http://ijmse.iust.ac.ir/article-1-3511-en.html

Superior Photocatalytic Efficiency with Titania (TiO2)-Polyaniline (PANI) Nanocomposite for Rapid Carbol Fuchsin (CF) Dye Degradation

Satish Ahire

, Arun Patil

Abstract: (6388 Views)

Hybrid photocatalysts, comprising both inorganic and organic polymeric components, are the most promising photocatalysts for the degradation of organic contaminants. The nanocomposite, Titania-Polyaniline (TiO₂-PANI) was synthesized using the chemical oxidative polymerization method. Various characterization techniques were employed to assess the properties of the catalysts. The ultraviolet diffuse reflectance spectroscopy (UV-DRS) analysis revealed that the TiO₂ absorbs only UV light while the TiO₂-PANI nanocomposite absorbs light from both UV and visible regions. The X-ray diffraction (XRD) results confirmed the presence of TiO₂(anatase) in both TiO₂ nanoparticles and TiO₂-PANI (Titania-Polyaniline) nanocomposite. The phases of the catalysts were verified through Raman, TEM, and SAED techniques where all results are in good agreement with each other. The average crystallite size of TiO₂ nanoparticle and TiO₂-PANI nanocomposite were 13.87 and 10.76 nm. The thermal stability of the catalysts was assessed by the Thermal gravimetric analysis (TGA) technique. The order of the thermal stability is TiO₂ > TiO₂-PANI > PANI. The crystal lattice characteristics were confirmed using Transmission electron microscopy (TEM). The surface area measurements were confirmed from the Brunauer-Emmett-Teller (BET) study and were employed for the evaluation of the photocatalytic efficiency of both, TiO₂ nanoparticles and TiO₂-PANI nanocomposite catalysts. The energy dispersive spectroscopy (EDS) study was employed for elemental detection of the fabricated materials. While Raman spectroscopy was employed for the chemical structure and the phase characteristics of the materials. The standard conditions for the degradation of the CF dye were 8 g/L of catalyst dosage, 20 mg/L of dye concentration, and a pH of 7. The TiO₂-PANI nanocomposite exhibited superior efficiency as compared to pure TiO₂nanoparticles, achieving almost 100 % degradation in just 40 minutes.

Keywords: TiO2–PANI nanocomposite, Carbol fuchsin dye, TEM, Water purification