Iranian Journal of Materials Science and Engineering

---

In the present research influences of different combinations of five types of inoculants and four types of nodularizers on eutectic nucleation in ductile cast iron were studied. The alloys were kept at 1320°C for 0, 5, 10, 15 and 20 min under nitrogen atmosphere. Cooling curves and image analysis were used to characterize the influence of holding time and different combinations of inoculants and nodularizers on the graphite morphologies and eutectic nucleation. When dominant morphology of graphite is spheroidal or flake, by decreasing the different combinations of nodularizers and inoculants fading resistance, temperature of eutectic undercooling decreases. Nevertheless, when there is combination of spheroidal, vermicular and flake graphites temperature of eutectic undercooling increases by reduction of material fading resistance.

---

The hot cracking susceptibility can be determined by establishing the transition temperature between brittle and ductile fracture at high temperature tensile testing of in situ solidified samples. High temperature tensile properties were determined for commercial cathodic pure Cu and Cu- 30%Zn alloy. The transition temperatures for pure Cu and Cu-30%Zn were evaluated from ultimate tensile stress, true strain and area reduction at different testing temperatures. The results show that hot cracking in pure Cu also occurred below and near to its melting temperature. It can be proposed that in this case excess vacancies and vacancy diffusion and condensation are the dominating mechanisms for hot crack formation. The transition temperature for Cu- 30%Zn was much lower than its solidus temperature and this alloy has more susceptibility to hot cracking as compared to pure Cu. The effect of two different cooling rates (15 °C/min and 60 °C/min) on the transition temperature was investigated. The results show that by increasing cooling rate, the transition temperature will increase. The morphology of fracture surfaces for both ductile and brittle modes were evaluated by SEM Two different morphologies, i.e. interdendiritic and intergranual fracture, was found.

---

Abstract: Strength at elevated temperatures and thermal shock resistance of austempered ductile irons at high temperatures has been less intentioned, because of instability of ausferrite phase. In this research the tensile properties of this iron and pearlitic ductile cast iron have been investigated by short time high temperature tensile tests. Also thermal shock tests were done at the molten lead bath at 1000 􀁱C . In these experiments, at first samples were immersed partially in the molten lead bath for 25 seconds and then either cooled in air or quenched in water. Results of short time high temperature tensile and thermal shock tests showed that ADI samples have higher strength and shock resistance than the pearlitic ductile samples.

---

Abstract: Ball mills are used in the last stage of ore processing for grinding raw materials. Forged 70Cr2 alloy steel and Austempered Ductile Iron (ADI) balls are materials from which grinding balls are made for Sarcheshmeh Copper Plant (SCP) ball mills. In the present study wear and impact properties of these two kinds of balls have been investigated. Some balls randomly were selected as samples. They were cut to investigate the cross section under optical and scanning electron microscopes. The microstructure of the sample balls was studied and quantitative measurements of microstructural features were performed. The hardness of different parts of cross sections of balls was measured. The wear resistance of the balls was measured by Pin on Disc method. Repeated dropt test was employed to evaluate impact resistance of the balls. The microstructure of ADI balls consisted of bianitic matrix with graphite nodules and some retained austenite and martensite. Micro cracks and porosities in the cast structure were frequently observed. In the case of forged steel balls the microstructure composed of tempered martensite in outer area and bianitic structure with some tempered martensite in central areas. The wear and impact resistance of forged steel balls were markedly higher than those of ADI balls. The difference was consistent with the differences between the microstructures of the two kinds of balls. Cast structure with microcracks and shrinkage porosities in ADI balls gives rise to lower impact resistance.