Search published articles


Showing 2 results for Okati

N. Okati, M. R. Mosavi, H. Behroozi,
Volume 13, Issue 4 (December 2017)
Abstract

Node cooperation can protect wireless networks from eavesdropping by using the physical characteristics of wireless channels rather than cryptographic methods. Allocating the proper amount of power to cooperative nodes is a challenging task. In this paper, we use three cooperative nodes, one as relay to increase throughput at the destination and two friendly jammers to degrade eavesdropper’s link. For this scenario, the secrecy rate function is a non-linear non-convex problem. So, in this case, exact optimization methods can only achieve suboptimal solution. In this paper, we applied different meta-heuristic optimization techniques, like Genetic Algorithm (GA), Partial Swarm Optimization (PSO), Bee Algorithm (BA), Tabu Search (TS), Simulated Annealing (SA) and Teaching-Learning-Based Optimization (TLBO). They are compared with each other to obtain solution for power allocation in a wiretap wireless network. Although all these techniques find suboptimal solutions, but they appear superlative to exact optimization methods. Finally, we define a Figure of Merit (FOM) as a rule of thumb to determine the best meta-heuristic algorithm. This FOM considers quality of solution, number of required iterations to converge, and CPU time.

E. Babaei, M. Shadnam Zarbil, E. Shokati Asl,
Volume 15, Issue 1 (March 2019)
Abstract

In this paper, a new topology for cascaded multilevel inverter based on quasi-Z-source converter is proposed. In the proposed topology the magnitude of output DC voltage is not limited to the sum of magnitude of DC voltage sources. Moreover, the reliability of the circuit due to capability of short circuit by Z-source network is increased. The quasi-Z- source converter in different modes is analyzed and the voltage gain is obtained. Also, the values of quasi-Z-source network components are designed. In the proposed topology, the number of DC voltage sources, the number of switches, installation area and cost in comparison with conventional multilevel inverters are significantly reduced. Three algorithms to determine the magnitude of DC voltage sources are proposed. Then the optimal structures for the minimum number of switches and DC voltage sources to generate the maximum voltage levels are presented. Moreover, the control method for the proposed topology is described. To verify the performance of the proposed topology, simulation and experimental results of proposed topology are presented.


Page 1 from 1     

Creative Commons License
© 2022 by the authors. Licensee IUST, Tehran, Iran. This is an open access journal distributed under the terms and conditions of the Creative Commons Attribution-NonCommercial 4.0 International (CC BY-NC 4.0) license.